1. Operators must receive pre-job training and pass the assessment before they can work, and should strictly abide by the operating procedures.
2. Except for the necessary maintenance personnel, it is strictly forbidden for non-personnel to operate the equipment or change the setting parameters.
3. The roller speed ratio is recommended to be set within the range of 1.3 to 1.5.
4. The air heater must be activated only after the drying fan has been activated.
5. When adjusting the gap between the coating roller and the backing roller, the principle should be to just wipe off the slurry on the coating roller without jamming the backing roller. It is necessary to ensure that the two rollers are parallel and the gap is consistent (there must be a gap).
6. After resetting the parameters, be sure to press the enter button to change the parameters.
7. Clean the hopper, scraper, coating roller and backing roller with alcohol or acetone immediately after each shift, and the surface must not be scratched or damaged.
8. Pay attention to keep the back roller cylinder and linear slide rail clean and lubricated.
9. The bearing parts of the machine must be lubricated regularly, and the gearbox must be replaced or replenished regularly.
10. Once a problem is found during operation, it must be recorded immediately and notified to the relevant department so that it can be dealt with in a timely manner.
11. Do a good job in the 5S work of the equipment at all times, and keep the equipment and surrounding environment clean and tidy.
